Asus Dual Wan Load Balance Problems

  1. Asus Dual Wan Load Balance Problems Solving
Asus dual wan load balance problems pdf
Tags: bonding, multi-wan, load balancer
Dual-wan (multi-wan) routers, a.k.a. load balancers, allow you to use multople internet connections, and will generally double the overall throughput of your network, however, they will not increase the download speed of a single connection, or a single download.
They are usefull in environments with multiple simultaneous connections, where different transfers can be routed over different external IP addresses, effectively doubling the combined speed of all simultaneous transfers. One notable exception is using P2P software, or other similar programs that open multiple connections for the same download.
The most common load balancing routers support per-destination or per-packet balancing. Per-destination load balancing means the router distributes the packets based on the destination address. Given two paths to the same network, all packets for destination1 on that network go over the first path, all packets for destination2 on that network go over the second path, and so on. This preserves packet order, with potential unequal usage of the links. If one host receives the majority of the traffic all packets use one link, which leaves bandwidth on other links unused.
Per-packet load-balancing means that the router sends one packet for destination1 over the first path, the second packet for (the same) destination1 over the second path, and so on. Per-packetload balancing guarantees equal load across all links. However, there is potential that the packets may arrive out of order at the destination because differential delay may exist within the network.
Some business grade routers may also support unequal cost load-balancing (IGRP and EIGRP routing processes), setting preferred routes, OSPF cost, BGP path selection algorithm, etc.
Note: Reportedly, some older residential dual-wan routers may have buggy implementations, causing some issues with VoIP,VPN and even SSL connections, especially if using per-packet balancing.

H ow do I setup a multi-WAN load balancing and failover on pfSense router with two ADSL or cable or leased-line or FTTH (Fiber to the home) connections? In this tutorial you will learn how to configure pfSense to load balance and fail over traffic from a LAN to multiple Internet connections (WANs) i.e. Vista mce ir blaster drivers for mac. If you want to use the 2 WAN connections at the same you have to chose the option Load Balancing. Make sure to put correct data in the field Max Bandwidth provided by ISP. And for the Network Service Detection, whatever IP you chose make sure that it replies to ping and will not give false positive for WAN failure.

Asus Dual Wan Load Balance Problems Solving

rate: avg:
I have a 'limited' dual WAN setup working with BitTorrent. A torrent client should be assigned to one WAN interface exclusively for it to work well. I use source local IP and source port ranges (set in advanced settings of ĀµTorrent) to accomplish this, and have two clients seeding for each IP.
Automatic load balancing where the client can establish connections via both WANs didn't work well enough. Remote peers eventually saw both of my IPs and tried to establish new connections to the one that was currently not connected to them. When my peer received the new connection, the previous one having the same peer-id was terminated, the peer was 'kicked' by my client, and the new connection took its time to ramp up to full speed (subject to latency and TCP slow start). The WAN interfaces kept switching around like this every few minutes.
I use MikroTik 'Per Connection Classifier' to distribute other connections (not bittorrent). The 'both addresses' mode is the safest. A pair of hosts local and remote always use the same interface.